FileZilla Client Tutorial (en): Difference between revisions

From FileZilla Wiki
Jump to navigationJump to search
(lkdqGfDc)
(OIGMzmFqkbRxYgtQ)
Line 1: Line 1:
The windows are glezad at the exterior with glazing putty.  From outside, use a glazing tool ( less than 5 bucks at any hardware store ) or a putty knife and remove the old putty. It will probably be very brittle and chip right out. The glass is held in place with glazier's points; very small metal points which are driven into the wood frame to hold the window.  Remove the points with the point of the tool and the broken glass.  Measure the wood opening, deduct 1/8  from the measurement. That is the size glass you need. Also, measure the thickness of the glass, it's probably 1/8  thick. A hardware store or glass co. can cut you a new piece of single strength glass. Buy a can of glazier's putty, a box of points and the aforementioned glazing tool. Set the glass in the opening, you can put a small dab of putty in the corners to hold it while you then set the new glazier's points.  Probably 2 at the bottom and 2 at the top.  Be careful not to hit or stress the glass when you press them in. Apply the glazing putty all around the exterior and tool it with the glazing tool to a slight taper.  You'll be a pro by the time you're done with the first piece.
Aluminum window have a  dearcotive trim that actually hold the glass in place like putty used to of old wood windows. you will need to use a thin blade perhaps a sturdy razor knife to gently get between the trim  base of the window frame. Lift gently so you can get under it with the putty knife and work toward the corners and it should pop up. Replace your window applyong a thin bead of silicon first to secure the window and seal from heat/cold loss then snap the trim back in place. Not difficult at all.

Revision as of 02:05, 27 September 2012

Aluminum window have a dearcotive trim that actually hold the glass in place like putty used to of old wood windows. you will need to use a thin blade perhaps a sturdy razor knife to gently get between the trim base of the window frame. Lift gently so you can get under it with the putty knife and work toward the corners and it should pop up. Replace your window applyong a thin bead of silicon first to secure the window and seal from heat/cold loss then snap the trim back in place. Not difficult at all.

Retrieved from "https://wiki.filezilla-project.org/wiki/index.php?title=FileZilla_Client_Tutorial_(en)&oldid=19836"